Different types of the MKM - line:

The goal of our closures is to avoid the problem of the earlier, complicated and dangerous hot shrinking system. This is increasingly successful, because we can exceed the expectations of both technology and economy.

HS systems are extremely sensitive to environmental impact during the processing. Usually this is causing high error rates. These closures are hard to open and not reusable. After opening they were a hazardous waste.

Your advantages using our cable closures:

suitable for all kinds of cables

telecommunications

fibre optics; the MAM closure can hold FO splice cases

plastic coated copper cables

also suitable for lead covered cables

power cables

operating voltage up to 1000 Volt

reducing the instruction costs

very installation friendly, no need for special training

reducing the mounting costs

no need of expensive tools or external energy (gas, electricity, ...)

very easy, quick and uncomplicated to mount

noticeable reduction of needed time for mounting

no delay as a result of necessary cooling

reduction of service costs

very easy to reopen

very easy to gain access to splices for several times

considerable reduction of follow-up costs

easy to use several times

excellent characteristics

high mechanical firmness, corrosion-resistant, acid resistant

seperate cable clamp for each input

reduction of costs due to mistakes

absolute watertight, very low error rate

reduces storage costs

covers all cable installations, simple to manage

reduces scheduling effort

for use both above and below earth, in a shaft or outside

usable as an in-line closure or branch-off closure

usable for 2 to 6 cables (4 to 12 with double end caps)

case can easily be changed from an in-line to a branch-off closure type